PC BECOME BLUE

Last month a lot of call frm friends asked about "Bluescreen Error Problem" n "What to do".

My answer " EZ or DIY ".

EZ -- Send it to PC centre to get rip off . settle ur problem.

DIY-- Follow one of these step.

BlueScreen

This r few example of Bluescreen. how it happen ? many reason.eg.

- hardware / Driver (that u just install)

-RAM faulty

-Virus n so n so n so so so....... Breapa banyak "SO" daa...

1) Goto Safemood n Restore to best known configure/ time b4 bluescreen happen.

Restart PC then taping F8 until the "Advance Boot Options" menu comes up.

Then Use up and down arrow buttons to navigate the menu, select "Safe Mode" and hit Enter.

Wait until safemood screen pop up.

Click on the START button and navigate to the Accessories folder. There you will see a folder entitled "System Tools," navigate to that folder and click on System Restore

"Restore my computer to an earlier time" is selected and click .......NEXT.

Choose - date - that you want to restore your computer and click... NEXT

The last page of the System Restore will pop up with your date that you have chosen and click.... NEXT.

The system will reboot and the computer blue screen will be gone. ( END)

2) Take Note the message on the blue screen, especially the numbers. Check it in Microsoft's Help and Support Knowledge Base (this site helps you on any windows code you may have). Also, put the text of the error message in a search engine and check the Internet. (if you can, if not see if you can get online with another one.) .... END....

3) Switch Off Power, remove RAM / Memory card n replace it with the good one/new.

If you have more than one memory module, remove one and start the computer with only one installed. If you are still getting the blue screen, replace that memory module with the one you took out first then power on the computer. Its must b same type and speed that your motherboard supports.

eg.(SDRAM, Double Notch, 168 pins), (DDR=Single Notch, 184 pins), (DDR2= Single Notch, 240 pins).

When removing the memory modules, do not touch the contacts as a small amount of static electricity can render the module useless.

.....END....

4) Have u recently installed a new piece of hardware in your computer system and after which you start receiving the blue screen error, more than likely the new piece of hardware is causing the error.

if you have installed additional drivers for a particular device and after which you get the blue screen error, then there are probably some driver conflict going on and you will need to uninstall the old device drivers or the one you have recently installed. (Check device manufacturer’s websites for fixes and patches)

...... END.......

5) Try 2 boot from windows XP and then choose repair console (press R) then choose the partion with windows XP you want to repair by typing in the given integer (1,2..) followed by enter key and put administrator password if asked and press enter. Eventually you will see:

C:\windows> and a cursor blinking then type in chkdsk /r press ..... enter

C:\windows> with a blinking cursor in-front then type EXIT (small letters are recommended)

The computer will then restart and boot without any failure.

....... END ......

Hope these few method solution can solve your Problem.